Introdução

This guide will show you the steps to remove the headband.

Peças

Não são necessárias peças.

  1. Remove the two screws on the underside of the headband with the PH0 Phillips screw driver. Remove the two screws on the underside of the headband with the PH0 Phillips screw driver.
    • Remove the two screws on the underside of the headband with the PH0 Phillips screw driver.

  2. Free shipping on all orders over US$100,00 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  3. With the headband fully extended, hold the base of the headband with one hand and with your other hand, hold the top of the headband. With force, pull upwards.
    • With the headband fully extended, hold the base of the headband with one hand and with your other hand, hold the top of the headband.

    • With force, pull upwards.

  4. Remove the rail-piece that is now sticking up by pulling it up and out of the headphone. Repeat on the opposite side and the headband will be released. During reassembly, make the sure the rail-pieces match their respective sides so the headband reinserts properly.
    • Remove the rail-piece that is now sticking up by pulling it up and out of the headphone.

    • Repeat on the opposite side and the headband will be released.

    • During reassembly, make the sure the rail-pieces match their respective sides so the headband reinserts properly.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Garrett Leung

Member since: 16-04-2013

883 reputação

8 Guides authored

Equipe

Cal Poly, Team 10-40, Amido Spring 2013 Membro de Cal Poly, Team 10-40, Amido Spring 2013

CPSU-AMIDO-S13S10G40

4 Membros

20 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 6

Últimos 30 dias: 15

Todo: 526