Introdução

This guide shows how to replace the metal sleeve on the Pioneer MXT-X366BT. This guide can act as a prerequisite for replacing the internal components of the radio, although the metal sleeve is also available as a replacement part.

Note: The radio must be removed from the vehicle for this guide. If the radio is currently installed in the vehicle, removal may require special assistance.

Peças

Não são necessárias peças.

  1. Apply small amount of pressure inward with a plastic opening tool to release bottom clip.
    • Apply small amount of pressure inward with a plastic opening tool to release bottom clip.

    • Pry the top clip with the plastic opening tool to release it.

    • The head unit is symmetrical and has the same amount of clips on the other side.

    Adicionar comentário

  2. Remove the face plate holder.
    • Remove the face plate holder.

    Adicionar comentário

    • Remove the six 5mm Phillips-head screws with Philips #2 screwdriver.

    Adicionar comentário

    • Remove the inner three 5mm Phillips head screws, with a Phillips #2 screwdriver, attached to the metal backing.

    • Remove the metal backing that is now free.

    Adicionar comentário

    • Carefully slide the metal casing forward.

    • Metal piece standing is the rear of the head unit.

    • Edges are sharp.

    Adicionar comentário

    • Lift the metal casing from the rear and pull it away.

    • Edges are sharp.

    Adicionar comentário

    • The metal casing is now fully removed.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Blaine Kaiser

Member since: 22-03-2018

145 reputação

Autoria de 1 guia

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 5

Todo: 90