Conserte seus objetos Comunidade Loja

Philips Sonicare FlexCare Spring Replacement

Escrito Por: Joanna Moraza (e 4 outros contribuidores)
  • Comentários: 0
  • Favoritos: 2
  • Execuções: 3

Dificuldade

Moderado

Passos

6

Tempo necessário

5 minutos

Partes

1

Sinalizadores

2

Slice and Dice

Despedaçar

As etapas neste guia devem se dividir e serem feitas em uma série de guias de pré-requisito.

Better Introduction

Melhor Introdução

Melhore este guia, completando ou revendo a sua introdução.

Introdução

This guide will help you replace the spring in your Philips Sonicare FlexCare toothbrush.

Ferramentas

Peças

Nenhum componente especificado.

  1. Pull the brush head away from the handle to remove it.

    • Pull the brush head away from the handle to remove it.

    Editar

  2. Push the flat edge of a nylon or metal spudger between the seal and the toothbrush body and pry it up. Do this on each side until the seal is partially sticking out on all sides. Push the flat edge of a nylon or metal spudger between the seal and the toothbrush body and pry it up. Do this on each side until the seal is partially sticking out on all sides.

    • Push the flat edge of a nylon or metal spudger between the seal and the toothbrush body and pry it up. Do this on each side until the seal is partially sticking out on all sides.

    Editar

  4. Apply pressure to the shaft by pressing it against a firm and flat surface. Continue to apply pressure until the interior electronics are exposed.

    • Apply pressure to the shaft by pressing it against a firm and flat surface. Continue to apply pressure until the interior electronics are exposed.

    Editar

  5. Grab the circular, plastic base with the o-ring and pull it outward.

    • Grab the circular, plastic base with the o-ring and pull it outward.

    Editar

  6. Pull off the black rubber ring with a metal or nylon spudger until it clears the metal piece that holds it in place. Pull the ring out.

    • Pull off the black rubber ring with a metal or nylon spudger until it clears the metal piece that holds it in place. Pull the ring out.

    Editar

  7. Remove the spring from the rubber ring and replace it with the new spring.

    • Remove the spring from the rubber ring and replace it with the new spring.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

3 outras pessoas concluíram este guia.

Autor(a)

com 4 outros contribuidores

Joanna Moraza

Membro desde: 14/04/2015

1.407 Reputação

2 Guias de autoria

Emblemas: 15

+12 outros emblemas

Equipe

Cal Poly, Team 4-6, Maness Spring 2015 Membro de Cal Poly, Team 4-6, Maness Spring 2015

CPSU-MANESS-S15S4G6

4 Membros

22 Guias de autoria

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 6

Últimos 30 dias: 39

Duração total: 3,366