Introdução

This guide is for the Philips Sonicare 2 series HX6211/46 toothbrush. It shows you how to replace the motor for this toothbrush. He is a link for a guide how to soldering which will be needed for this guide. Como soldar e dessoldar contatos

  1. Remove brush on top of device.
    • Remove brush on top of device.

  2. Remove the 12 mm T8 Torx screw from the bottom of the toothbrush. After removing the screw, pry off the base with a plastic opening tool.
    • Remove the 12 mm T8 Torx screw from the bottom of the toothbrush. After removing the screw, pry off the base with a plastic opening tool.

  3. Remove the internal electronic mechanism from the housing by prying the red clips shown in the figure. This removes the charging port. Be very careful not to damage the charging port during this step.  Otherwise you will have to solder this part back to the device as shown in the second figure.
    • Remove the internal electronic mechanism from the housing by prying the red clips shown in the figure. This removes the charging port.

    • Be very careful not to damage the charging port during this step. Otherwise you will have to solder this part back to the device as shown in the second figure.

  4. Free shipping on all orders over US$100,00 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  5. Next you will be able to remove the internal electronic mechanism as shown in the figure.
    • Next you will be able to remove the internal electronic mechanism as shown in the figure.

  6. Remove the white battery cover as shown in the figure.
    • Remove the white battery cover as shown in the figure.

  7. Remove the white circuit board cover as shown. This cover will require you to pry off the piece from the groves .
    • Remove the white circuit board cover as shown. This cover will require you to pry off the piece from the groves .

  8. Disassemble the device. Remove the plastic piece over the brush attachment as shown. Object can be removed by hand as shown. No tool is required.
    • Disassemble the device. Remove the plastic piece over the brush attachment as shown. Object can be removed by hand as shown. No tool is required.

  9. Desolder the motor from the circuit board at the two locations shown.
    • Desolder the motor from the circuit board at the two locations shown.

  10. Remove the bad motor.
    • Remove the bad motor.

Linha de Chegada

Jonathan Jarvis

Member since: 01-04-2016

452 reputação

4 Guides authored

Equipe

IUPUI, Team S6-G2, Baechle Fall 2017 Membro de IUPUI, Team S6-G2, Baechle Fall 2017

IUPUI-BAECHLE-F17S6G2

3 Membros

4 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 6

Últimos 30 dias: 24

Todo: 453