Introdução

This is a guide on how to replace the speakers on a Philips DS3000/37 Audio Dock. Because this repair requires soldering, the soldering technique page linked here might be helpful. Como soldar e dessoldar contatos

  1. Pry off the front fascia by inserting a plastic opening tool between the fascia and white casing.
    • Pry off the front fascia by inserting a plastic opening tool between the fascia and white casing.

    Adicionar comentário

  2. Pull the ZIF (zero insertion force) white ribbon out of the circuit board by hand located on the back of the front fascia. Be careful when pulling it out of the connector.
    • Pull the ZIF (zero insertion force) white ribbon out of the circuit board by hand located on the back of the front fascia. Be careful when pulling it out of the connector.

    Adicionar comentário

    • Remove the 10 screws from the black internal housing (6 black screws, 4 silver screws). They are all phillips #1 screws and the black screws are 10 mm in length and the silver screws are 8 mm in length.

    Adicionar comentário

    • Slowly pry around the black housing with the plastic opening tool to remove it from the back housing.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the 4 phillips #1 head silver screws from the green circuit board. They are located on the four corners of the board and are 8 mm in length.

    Adicionar comentário

    • Remove the black tube (speaker port) by unscrewing the silver phillips head #1 screw (8 mm in length) that connects it to the black housing. Pull it off from where it wraps around the black housing's mating port.

    Adicionar comentário

    • Remove the 4 silver phillips head #1 screws from the back of the speaker that are 7 mm in length.

    Adicionar comentário

    • Remove the speaker from the black housing.

    Adicionar comentário

    • Remove about an inch of the black sponge insulation from around the red (positive) and black (negative) speaker wires.

    Adicionar comentário

    • Use the soldering iron to heat up the terminal spots on the speaker and remove each wire (red and black).

    Adicionar comentário

    • Strip about a quarter inch of the rubber insulation away from each of the speaker wires (red and black wires) using the 6 inch wire strippers.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Andrew McAuliffe

Member since: 24-02-2014

128 reputação

Autoria de 1 guia

Equipe

i hardly difficult to treat 2 defective speakers. i find the flat cable a little loose on the main plate. thank you!!!

araujojraa - Responder

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 4

Últimos 30 dias: 23

Todo: 1,682