Ir para o conteúdo principal

Pentax Optio WP Motherboard and Flash Unit Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

O que você precisa

  1. Pentax Optio WP Motherboard and Flash Unit Replacement, Motherboard and Flash Unit: passo 1, imagem 1 %32
    • Remove the 4 mm black screw on the bottom right corner of the mother board.

    • The black screw may be hard to remove. Use the tweezers if necessary.

  2. Pentax Optio WP Motherboard and Flash Unit Replacement: passo 2, imagem 1 %32
    • With the tweezers, carefully peel back the copper ribbon that was underneath the black screw.

  3. Pentax Optio WP Motherboard and Flash Unit Replacement: passo 3, imagem 1 %32
    • Remove the 2.5 mm silver screw from the upper left corner of the motherboard.

  4. Pentax Optio WP Motherboard and Flash Unit Replacement: passo 4, imagem 1 %32 Pentax Optio WP Motherboard and Flash Unit Replacement: passo 4, imagem 2 %32
    • Press down on the metal plate and gently lift the motherboard up from left to right.

    • Be cautious when lifting the motherboard since there is a copper ribbon and two wires attaching the motherboard to the flash unit.

    • Reorient the camera so you are looking at the top edge with the metal plate on the right.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Derek

Membro desde: 01/21/11

746 Reputação

Autoria de 5 guias

Equipe

Cal Poly, Team 1-13, Amido Winter 2011 Membro de Cal Poly, Team 1-13, Amido Winter 2011

CPSU-AMIDO-W11S1G13

Membros da 5

Autoria de 18 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 236