Este guia tem alterações mais recentes. Mudar para a última versão não verificada.

Panasonic PV-GS9 outercasing replacement

Escrito Por: Trevor Johnson (e 10 outros contribuidores)

Comentários: 0
Favoritos: 1
Execuções: 1

Panasonic PV-GS9 outercasing replacement

Dificuldade

Moderado

Passos

Tempo necessário

10 - 15 minutos

Introdução

In order to repair the problems that may arise while using the Panasonic PV-GS9 you must disassemble the camcorder entirely. This will allow you to have three large pieces of the camcorder from which all the repairs can be made.

Ferramentas

Comprar estas ferramentas

Phillips #00 Screwdriver

$6.99

Comprar
Spudger

$3.99

Comprar

Peças

Nenhum componente especificado.

Passo 1 Outer Casing

Using a plastic opening tool, remove the record/playback and record/power control knobs from the camcorder.

Using a plastic opening tool, remove the record/playback and record/power control knobs from the camcorder.

Editar

Passo 2

Using a #00 Phillips head screwdriver, remove the two 4.5mm screws from the camcorder.

Open the tape compartment.
Using a #00 Phillips head screwdriver, remove the two 4.5mm screws from the camcorder.

Editar

Passo 3

Use a plastic opening tool to remove the gray trim piece from top of the camcorder.

Take care when removing the trim piece. The plastic parts are fragile and can break easily.

Use a plastic opening tool to remove the gray trim piece from top of the camcorder.
Take care when removing the trim piece. The plastic parts are fragile and can break easily.

Editar

Passo 4

Rotate the camcorder so that the eye piece is facing you.

Rotate the camcorder so that the eye piece is facing you.
Remove the battery.
Remove the four black 4.5mm screws, sitting behind the battery.
Remove the 5th screw to the right of the battery dock.
Be careful not to lose any screws whilst trying to remove them.

Editar

Passo 5

Rotate the camcorder so that the tape compartment is facing you.

Remove the single 4.5mm black screw above the hook for the hand strap.

Rotate the camcorder so that the tape compartment is facing you.
Remove the single 4.5mm black screw above the hook for the hand strap.
Undoing the strap on one end may help.
Rotate the camcorder so that the lens is facing you.
Remove the single 4.5mm black screw from the front panel.

Editar

Passo 6

Rotate the camcorder so that the bottom is facing towards you.

Remove the single remaining 4.5mm black screw from the bottom.

Rotate the camcorder so that the bottom is facing towards you.
Remove the single remaining 4.5mm black screw from the bottom.
Remove the four silver 4.5mm screws from the body.

Editar

Passo 7

Open the LCD screen on the side of the camcorder.

Open the LCD screen on the side of the camcorder.
Using a #00 screwdriver, remove the two 4.5mm silver screws located on either side of the hinge of the LCD screen.

Editar

Passo 8

Very carefully remove the front cover from the main body of the camcorder.

This should come apart with relative ease, however a plastic opening tool may help remove the panel.

Very carefully remove the front cover from the main body of the camcorder.
This should come apart with relative ease, however a plastic opening tool may help remove the panel.
There is a ribbon cable attached to the front panel and the camcorder body, so be careful not to pull that off when you remove this panel.