Peças

Não são necessárias peças.

  1. Remove protective flap by pulling directly out from the top.
    • Remove protective flap by pulling directly out from the top.

    • The two clips will pop out

    Adicionar comentário

  2. Remove Faceplate. There is a tab where the finger is located in the picture that needs to be pulled up.
    • Remove Faceplate. There is a tab where the finger is located in the picture that needs to be pulled up.

    • The Faceplate will then easily lift off.

    Adicionar comentário

    • Using a a T5 Torx bit screwdriver, remove the four screws located on the back of the device turning counter clockwise.

    • The link to purchase this screwdriver is Located here.

    Adicionar comentário

    • This is what the device looks like once you have taken the screws out and opened the device.

    Adicionar comentário

    • The Motherboard and screen will pop out of the back case easily.

      • Be careful when doing this step, the components are fragile.

    Adicionar comentário

    • To remove the screen from the motherboard there are going to be three tabs that need to pulled up.

    • ** This step needs to be done with special care because it is very fragile.**

    • Once they are all three popped up the motherboard and screen will separate easily.

    Adicionar comentário

    • Click here for Palm m105 screen replacement

    • Now that the screen and motherboard are separated you may discard the broken screen. The best way to dispose of the broken screen is to: Recycle it

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Erik Thompson

Member since: 04-10-2011

31 reputação

5 Guides authored

Equipe

UW Stout, Team 1-3, Zhou Fall 2011 Membro de UW Stout, Team 1-3, Zhou Fall 2011

UWSTOUT-ZHOU-F11S1G3

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Todo: 430