Dificuldade
Moderado
Passos
11
Tempo necessário
- Display Screen 11 passos
Precisa de melhores imagens
Melhores fotos vão melhorar este guia. Ajude tirando, editando ou enviando novas delas!
Acidente de Marcação
Este guia precisa de melhores marcações. Ajude corrigindo ou fazendo algumas marcações.
Pré-requisitos ausentes
Este guia está faltando informações sobre como começar. Faça um guia de início!
Ajustador de passo
Este guia tem passos desnecessários. Tente ser mais conciso!
Introdução
This guide will provide instructions and visuals on how to replace the display screen.
Ferramentas
Peças
Não são necessárias peças.
-
Remove the batteries.
-
Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.
-
Remove rear cover by gently lifting it up from the bottom.
-
Carefully lift up the circuit board, which will also lift up the screen. Do so carefully to prevent breaking the connectors.
-
Lift the left side of the circuit board and open it as though it were a book.
-
Unplug the three connectors located on the right side of the circuit board with great caution and care. Do not pull by the cable, and be sure to pull the connector itself gently.
-
After separating the screen from the board, set aside the old display screen.
-
Replace with a new display screen.
-
Plug in the three connectors.
-
Close again like a book, and lay it gently into the front panel, screen facing outwards of the front panel.
-
Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Equipe
James Madison, Team 1-3, Allen Fall 2011 Membro de James Madison, Team 1-3, Allen Fall 2011
JMU-ALLEN-F11S1G3
5 Membros
5 Guides authored
