Introdução

If the front and/or rear cover is cracked, this guide will teach the user to remove the damaged cover and replace with a new one.

Peças

Não são necessárias peças.

Remove the batteries.
  • Remove the batteries.

Adicionar comentário

Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.
  • Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

Adicionar comentário

  • Remove rear cover by gently lifting it up from the bottom. To remove the front cover, flip the device over, and then separate the screen/circuit board from the cover.

Adicionar comentário

  • Set aside broken cover, and replace with a new cover.

Adicionar comentário

  • Close again like a book, and lay it gently into the front panel. Make sure the screen is facing outwards of the front panel.

Adicionar comentário

  • Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Anne Carey

Member since: 25-10-2011

1 reputação

3 Guides authored

Equipe

James Madison, Team 1-3, Allen Fall 2011 Membro de James Madison, Team 1-3, Allen Fall 2011

JMU-ALLEN-F11S1G3

5 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 3

Todo: 461