Peças

Não são necessárias peças.

Make sure your Palm Pre is turned off before disassembling the phone.
  • Make sure your Palm Pre is turned off before disassembling the phone.

  • Snap off the back panel to reveal the battery.

Adicionar comentário

Carefully pull up on the tab to remove the current battery.
  • Carefully pull up on the tab to remove the current battery.

Adicionar comentário

Use the T5 Torx Screwdriver to remove the six screws holding the backing frame in place. Use the T5 Torx Screwdriver to remove the six screws holding the backing frame in place.
  • Use the T5 Torx Screwdriver to remove the six screws holding the backing frame in place.

Adicionar comentário

Locate the hinge that covers the black and white GPS and DIV antennas. (The hinge will be located in the red box as portrayed in the picture.)
  • Locate the hinge that covers the black and white GPS and DIV antennas. (The hinge will be located in the red box as portrayed in the picture.)

  • Use a spudger to pry open the hinge.

  • Use tweezers to disconnect the antennas from the keypad control board.

Adicionar comentário

Use a spudger to pry off the (black and yellow) back frame. Disregard the main part of the phone at this point and look only at the inside of the removed back frame. (You will need the main part of the phone for access to the keyboard and motherboard)
  • Use a spudger to pry off the (black and yellow) back frame.

    • Disregard the main part of the phone at this point and look only at the inside of the removed back frame. (You will need the main part of the phone for access to the keyboard and motherboard)

Adicionar comentário

Find the small circuit board at the top right and desolder the wires that are connected to it.
  • Find the small circuit board at the top right and desolder the wires that are connected to it.

    • This step is only necessary for antenna removal.

Adicionar comentário

Remove the two ribbon cable connectors using tweezers.
  • Remove the two ribbon cable connectors using tweezers.

Adicionar comentário

Use a spudger to remove the keypad control board. There is heavy adhesive connecting this part to the keypad sensors.
  • Use a spudger to remove the keypad control board.

    • There is heavy adhesive connecting this part to the keypad sensors.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

noha

Member since: 12-04-2012

139 reputação

12 Guides authored

Equipe

Cal Poly, Team 7-31, Maness Spring 2012 Membro de Cal Poly, Team 7-31, Maness Spring 2012

CPSU-MANESS-S12S7G31

3 Membros

16 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 707