Introdução

This guide will take you through all the steps to sucessfully install a new logic board to your Olympus D590 camera.

Peças

Não são necessárias peças.

Flip camera so you are looking at the bottom.
  • Flip camera so you are looking at the bottom.

  • Unscrew all 5 base plate screws.

Adicionar comentário

Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
  • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

Adicionar comentário

Unscrew the single screw located next to the battery slot.
  • Unscrew the single screw located next to the battery slot.

Adicionar comentário

Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.
  • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

  • Lift the rubber plate exposing the ports beneath.

Adicionar comentário

Unscrew the 2 screws next to the USB and AC ports.
  • Unscrew the 2 screws next to the USB and AC ports.

Adicionar comentário

Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.
  • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

Adicionar comentário

Pull off the faceplate to reveal the inside of the camera.
  • Pull off the faceplate to reveal the inside of the camera.

  • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

Adicionar comentário

Unscrew all 4 circled screws.
  • Unscrew all 4 circled screws.

Adicionar comentário

The logic board should now be loose and easily liftable.
  • The logic board should now be loose and easily liftable.

  • DO NOT lift the board out completely the wiring that is still connected must be disconnected before proceeding.

Adicionar comentário

Disconnect the 3 wiring strips from the device by gently pulling with tweasers from the base of the strip. Do not use sharp tweasers because the wiring might tear. Make sure to use small force so the wiring is not damaged.  It may help to gently wiggle the tape.
  • Disconnect the 3 wiring strips from the device by gently pulling with tweasers from the base of the strip.

  • Do not use sharp tweasers because the wiring might tear.

  • Make sure to use small force so the wiring is not damaged. It may help to gently wiggle the tape.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Sara

Member since: 15-04-2010

84 reputação

2 Guides authored

Equipe

Cal Poly, Team 28-23, Regan Spring 2010 Membro de Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 1,607