Introdução

Use this guide to remove the frame from the screen on your OLPC XO 4.0 Touch.

Peças

Não são necessárias peças.

Turn the laptop upside-down, with the handle facing away from you.
  • Turn the laptop upside-down, with the handle facing away from you.

Adicionar comentário

Pull the lock tabs towards the green outer edges of the laptop.
  • Pull the lock tabs towards the green outer edges of the laptop.

  • Hold the left lock tab in the unlock position until the battery is completely removed in the next step.

Adicionar comentário

  • Lift up on the middle of the battery to remove it from the device.

Adicionar comentário

  • Remove the two 4mm Phillips #1 screws underneath the screen on the right-hand side.

  • Rotate the screen 180° and remove the other two screws.

  • You will have to put your screwdriver through the handle in order to reach the middle screw for both sides.

Adicionar comentário

  • Remove the green side panel by pressing down on the small green button on the top and sliding the panel up.

  • Repeat the step above for the panel on the other side.

Adicionar comentário

  • Be careful not to pull the bottom too far out because a ribbon cable is under the frame and can easily break.

  • Gently lift up the lower part of the frame and pull it down to free the screen frame.

Adicionar comentário

  • Lift the black connector and pull the ribbon cable out by the purple tab, freeing the frame.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Ji Kim

Member since: 25-01-2013

18 reputação

3 Guides authored

Equipe

Cal Poly, Team 3-29, Amido Winter 2013 Membro de Cal Poly, Team 3-29, Amido Winter 2013

CPSU-AMIDO-W13S3G29

4 Membros

10 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 109