Peças

Não são necessárias peças.

Flip over the turntable and remove the 9 screws on the outer edges.
  • Flip over the turntable and remove the 9 screws on the outer edges.

Adicionar comentário

Remove the back cover by pulling it apart.
  • Remove the back cover by pulling it apart.

Adicionar comentário

  • Remove the clip located on the backside of the audio jack housing by gently pulling it out.

  • There will be some resistance but continue to pull gently.

  • The clip is located right underneath the audio jacks.

Adicionar comentário

  • Remove the screw that connects the black wire of the tone arm to the base of the audio jack housing.

Adicionar comentário

  • Gently pull the wire that you just unscrewed to release it from the clip.

Adicionar comentário

  • Remove the two screws connecting the circuit board to the tone arm.

Adicionar comentário

  • Remove the two remaining screws connecting the tone arm to the device.

Adicionar comentário

  • Flip the turntable back over to the top side.

  • Remove the counter weight located at the back of the tone arm.

Adicionar comentário

  • Push out the pin keeping the tone arm in place using a Phillips #00 screwdriver.

  • Once you have pushed the pin out with the screwdriver, pull the rest of it out using your hand.

Adicionar comentário

  • Pick up the tone arm and point the back end of it towards its base.

  • Push the back end of the tone arm into the hole.

  • Flip the turntable over and pull the tone arm all the way through the hole.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Nikolai

Member since: 12-10-2011

161 reputação

5 Guides authored

Equipe

Cal Poly, Team 17-14, Regan Fall 2011 Membro de Cal Poly, Team 17-14, Regan Fall 2011

CPSU-REGAN-F11S17G14

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 6

Últimos 30 dias: 40

Todo: 4,663