Introdução

This guide will help you remove the circuit board from the outer telephone case. You may need to remove the circuit board to repair internal components, such as buttons.

Peças

Não são necessárias peças.

Flip the phone over to view the back.
  • Flip the phone over to view the back.

  • Remove the power and phone cords.

Adicionar comentário

Remove the seven 8mm Phillips #2 screws.
  • Remove the seven 8mm Phillips #2 screws.

Adicionar comentário

  • Lift up the back cover slowly because there are still wires attached to the circuit board.

  • Lifting the back cover should not require a lot of force; simply lift with your fingertips.

Adicionar comentário

  • Disconnect the rubber piece by pulling it out of the slot, freeing the back cover completely.

Adicionar comentário

  • Remove the six 8mm Phillips #2 screws.

  • Pull the speaker phone cover straight up.

Adicionar comentário

  • Remove the red and white wires from the rubber casing rim.

Adicionar comentário

  • Lift out the speaker and set it away from the tray that holds it.

  • Then remove the black plastic tray at the bottom by lifting it straight up.

Adicionar comentário

  • Remove the two 8mm Phillips #2 screws.

Adicionar comentário

  • Pull the gray plastic casing away from the circuit board as you remove the clear, curved, plastic piece straight up.

Adicionar comentário

  • There are three clips on the circuit board to un-clip.

  • Unclip both back black clips with your fingertips.

  • Push the middle black clip towards the bottom of the picture with a flathead screwdriver.

Adicionar comentário

  • There's a brown ribbon still attached to the circuit board and phone case, so don't pull the circuit board completely off just yet.

  • Lift the edge of the circuit board over the phone case and slightly up, so the bottom of circuit board can be viewed.

Adicionar comentário

  • Push down each brown clip on either side of the brown metal strip using your fingertip.

  • Detach the circuit board from the brown ribbon.

Adicionar comentário

  • Remove the clear rubber casing.

  • Be careful not to flip over the front phone casing or all of the buttons will fall out.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Elizabeth

Member since: 21-01-2012

160 reputação

3 Guides authored

Equipe

Cal Poly, Team 10-35, Amido Winter 2012 Membro de Cal Poly, Team 10-35, Amido Winter 2012

CPSU-AMIDO-W12S10G35

4 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 8

Todo: 1,681