Nokia 6200 Classic Circuit Board Replacement

Introdução

This guide requires that the front plate and keypad already be removed. You will have to remove 6 screws and separate the circuit board from the rest of the phone.

O que você precisa

Passo 1 Front Plate

Nokia 6200 Classic Circuit Board Replacement, Front Plate: passo 1, imagem 1 %32

Nokia 6200 Classic Circuit Board Replacement, Front Plate: passo 1, imagem 2 %32

Nokia 6200 Classic Circuit Board Replacement, Front Plate: passo 1, imagem 3 %32

Pull up on both of the clips near the bottom of the phone as shown.
Lift off the front plate.

Editar

Passo 2

The keypad and LCD screen are revealed.

Editar

Passo 3 Circuit Board

Nokia 6200 Classic Circuit Board Replacement, Circuit Board: passo 3, imagem 1 %32

Nokia 6200 Classic Circuit Board Replacement, Circuit Board: passo 3, imagem 2 %32

Separate the keypad from the phone and place aside.
Wipe off any excess dust from where the keypad was attached to the phone.

Editar

Passo 4

Remove the 6 - 7.9 mm screws highlighted by the markers using the T-6 head on the screwdriver.

Editar

Passo 5

Separate the inside of the phone from the back of the phone.

Editar

Passo 6

Gently pull apart the circuit board from the rest of the phone.
There is a small connector holding these two pieces together, so use caution when pulling apart so as not to damage it.

Editar

Conclusão

To reattach the circuit board, line up the connector at the top of the board with the back of the LCD Screen attachment. Place the two boards together, and screw in the 6 screws.