Ir para o conteúdo principal

Introdução

This guide will help you remove the front panel of the controller. It is a prerequisite guide only.

Peças

Nenhum componente especificado.

  1. Pull down on the battery cover release lever and pull back to remove the cover. Pull down on the battery cover release lever and pull back to remove the cover.
    • Pull down on the battery cover release lever and pull back to remove the cover.

  2. Remove both batteries from the device.
    • Remove both batteries from the device.

  3. Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver. During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.
    • Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver.

    • During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.

  4. Carefully turn over the controller and place it on a flat surface. Slowly separate the top panel from the bottom panel.
    • Carefully turn over the controller and place it on a flat surface.

    • Slowly separate the top panel from the bottom panel.

    • The buttons are loose and may fall off the motherboard.

    • Once separated, set aside the top panel.

    • During reassembly, make sure the front panel lines up with the buttons so they slide back into place.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

JT Gryder

Membro desde: 12/04/2013

78 Reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 10-40, Amido Spring 2013 Membro de Cal Poly, Team 10-40, Amido Spring 2013

CPSU-AMIDO-S13S10G40

4 Membros

37 Guias de autoria

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 3

Últimos 30 dias: 11

Duração total: 1,175