Introdução

This guide shows how to remove the metal plate that covers the motherboard.

  1. Remove the expansion pack cover by pushing in the tab and pulling out.
    • Remove the expansion pack cover by pushing in the tab and pulling out.

  2. If your system uses a jumper pack, the same procedure applies to remove it.
    • If your system uses a jumper pack, the same procedure applies to remove it.

    • A small spoon can be used in place of a spudger.

    • Lever the expansion pack out using a metal spudger.

    • Remove the six screws on the bottom side indicated in the example with a gamebit head or screwdriver.

    • Remove the two front feet of the N64.

    • Rotate to top side up and lift off top cover.

    • Remove the fourteen screws indicated in the example using the larger Phillips screwdriver.

    • Remove the metal plate indicated in the example by sliding it back and then lifting it up.

    • Remove the two screws indicated in the example using the smaller Phillips screwdriver.

    • Remove the screw to the right of the LED light using the larger Phillips screwdriver.

    • Remove the small metal bracket from the back of the expansion pack slot.

    • Remove the small metal bracket from the front of the expansion pack slot with the metal spudger.

    • Remove the small metal bracket behind the expansion slot using the spudger.

    • Remove the seven screws indicated in the example using the larger Phillips screwdriver.

    • Lift off and remove the metal plate as indicated in the example.

Conclusão

To reassemble your device, follow these instructions in reverse order.

3 outras pessoas concluíram este guia.

LisaF818

Member since: 29-11-2009

101 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 5-4, Regan Fall 2009 Membro de Cal Poly, Team 5-4, Regan Fall 2009

CPSU-REGAN-F09S5G4

7 Membros

6 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 6

Últimos 30 dias: 31

Todo: 8,941