Conserte seus objetos Comunidade Loja

Ninja NJ600 Fan Replacement

Introdução

This guide will illustrate how to disassemble and replace the fan inside your blender.

O que você precisa

  1. Ninja NJ600 Fan Replacement, Blender Base Cover: passo 1, imagem 1 %32 Ninja NJ600 Fan Replacement, Blender Base Cover: passo 1, imagem 2 %32

    • Remove the five screws (13mm long, 6mm head diameter) using a Phillips #2 screwdriver.

    Editar

  2. Ninja NJ600 Fan Replacement: passo 2, imagem 1 %32 Ninja NJ600 Fan Replacement: passo 2, imagem 2 %32

    • Without removing any screws, you can pull the 2nd layer free from the base. Do this now and set it down gently next to the base.

    • The power cord runs through a hole in the side of this layer. Squeeze the cord and pull it through the hole to separate the layer from the cord.

    Editar

  4. Ninja NJ600 Fan Replacement: passo 3, imagem 1 %32 Ninja NJ600 Fan Replacement: passo 3, imagem 2 %32 Ninja NJ600 Fan Replacement: passo 3, imagem 3 %32

    • Using the Phillips #2 screwdriver, remove these six screws (13mm long, 6mm head diameter). Then carefully remove this layer, and rest it next to the blender base.

    • Be careful not to damage the two wires that are keeping this third layer attached to the base.

    Editar

  5. Ninja NJ600 Fan Replacement, Fan: passo 4, imagem 1 %32

    • Hold the fan steady and use a wrench or pliers to remove the nut in the image.

    • The fan is sharp. Use caution when handling with bare hands.

    • A towel or gloves may be useful when holding the fan for this step.

    Editar

  6. Ninja NJ600 Fan Replacement: passo 5, imagem 1 %32

    • Hold the fan and use the flathead 4.0 screwdriver to loosen the washer.

    • The fan is sharp, use caution when handling with bare hands.

    • You may use a towel or gloves to avoid handling the fan with your bare hands.

    Editar

  7. Ninja NJ600 Fan Replacement: passo 6, imagem 1 %32 Ninja NJ600 Fan Replacement: passo 6, imagem 2 %32

    • Slide the washer and fan off of the screw.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Autor(a)

com 4 outros contribuidores

Ryan Heller

Membro desde: 04/01/15

107 Reputação

Autoria de 1 guia

Emblemas: 5

+2 outros emblemas

Equipe

Cal Poly, Team 24-2, Lancaster Spring 2015 Membro de Cal Poly, Team 24-2, Lancaster Spring 2015

CPSU-LANCASTER-S15S24G2

Membros da 4

Autoria de 6 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 2

Últimos 30 dias: 13

Duração total: 1,335