Ir para o conteúdo principal

Este guia tem alterações mais recentes. Mudar para a última versão não verificada.

Nikon D90 Rear Case Replacement

O que você precisa

  1. Nikon D90 Rear Case Replacement, Rear Case: passo 1, imagem 1 %32 Nikon D90 Rear Case Replacement, Rear Case: passo 1, imagem 2 %32
    • Slide the eyepiece up and off the viewfinder.

  2. Nikon D90 Rear Case Replacement: passo 2, imagem 1 %32
    • Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.

    • Some screws may be JIS. Be wary of this if your PH000 does not feel like it is properly gripping the screws.

  3. Nikon D90 Rear Case Replacement: passo 3, imagem 1 %32
    • Remove the two 6.4mm Phillips screws on the right side of the camera, near the SD card slot.

  4. Nikon D90 Rear Case Replacement: passo 4, imagem 1 %32
    • Remove the two 6.4mm Phillips screws on the left side of the camera, near the I/O ports.

  5. Nikon D90 Rear Case Replacement: passo 5, imagem 1 %32
    • On the bottom of the camera,

    • remove the two 5.3mm Phillips screws

    • and the other two 6.3mm Phillips screws.

  6. Nikon D90 Rear Case Replacement: passo 6, imagem 1 %32 Nikon D90 Rear Case Replacement: passo 6, imagem 2 %32 Nikon D90 Rear Case Replacement: passo 6, imagem 3 %32
    • Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step.

  7. Nikon D90 Rear Case Replacement: passo 7, imagem 1 %32 Nikon D90 Rear Case Replacement: passo 7, imagem 2 %32
    • Lift the rear case off of the back of the camera.

    • Don't pull the casing completely off yet, as the ribbon cables are still connected.

    • Be mindful of the two clips, making sure to keep the bottom panel far enough away to clear them.

  8. Nikon D90 Rear Case Replacement: passo 8, imagem 1 %32
    • Set the rear casing off to the side so you can access the ZIF connectors.

    • The orientation shown in the picture seems to be the best position for the casing to sit comfortably without stressing the ribbon cable connections.

  9. Nikon D90 Rear Case Replacement: passo 9, imagem 1 %32 Nikon D90 Rear Case Replacement: passo 9, imagem 2 %32 Nikon D90 Rear Case Replacement: passo 9, imagem 3 %32
    • Disconnect the ribbon cables from their respective ZIF connectors on the logic board.

  10. Nikon D90 Rear Case Replacement: passo 10, imagem 1 %32
    • Separate the rear casing from the camera.

Conclusão

To reassemble your device, follow these instructions in reverse order.

8 outras pessoas executaram este guia.

Ryan Lutz

Membro desde: 09/27/11

3.008 Reputação

Autoria de 3 guias

2 comentários

good guidance,easy to follow,thanks

ramalingeswarao kaza - Responder

I want to replace my Nikon D90 DSLR bad LCD, this guide will save me from costly repairs.

ramalingeswarao kaza - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 4

Últimos 30 dias: 9

Duração total: 4,182