Slide the eyepiece up and off the viewfinder. Slide the eyepiece up and off the viewfinder.
  • Slide the eyepiece up and off the viewfinder.

Adicionar comentário

Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.
  • Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.

    • Some screws may be JIS. Be wary of this if your PH000 does not feel like it is properly gripping the screws.

Adicionar comentário

Remove the two 6.4mm Phillips screws on the right side of the camera, near the SD card slot.
  • Remove the two 6.4mm Phillips screws on the right side of the camera, near the SD card slot.

Adicionar comentário

Remove the two 6.4mm Phillips screws on the left side of the camera, near the I/O ports.
  • Remove the two 6.4mm Phillips screws on the left side of the camera, near the I/O ports.

Adicionar comentário

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
On the bottom of the camera,
  • On the bottom of the camera,

    • remove the two 5.3mm Phillips screws

    • and the other two 6.3mm Phillips screws.

Adicionar comentário

Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step. Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step. Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step.
  • Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step.

Adicionar comentário

Lift the rear case off of the back of the camera. Don't pull the casing completely off yet, as the ribbon cables are still connected.
  • Lift the rear case off of the back of the camera.

  • Don't pull the casing completely off yet, as the ribbon cables are still connected.

  • Be mindful of the two clips, making sure to keep the bottom panel far enough away to clear them.

Adicionar comentário

Set the rear casing off to the side so you can access the ZIF connectors.
  • Set the rear casing off to the side so you can access the ZIF connectors.

  • The orientation shown in the picture seems to be the best position for the casing to sit comfortably without stressing the ribbon cable connections.

Adicionar comentário

Disconnect the ribbon cables from their respective ZIF connectors on the logic board. Disconnect the ribbon cables from their respective ZIF connectors on the logic board. Disconnect the ribbon cables from their respective ZIF connectors on the logic board.
  • Disconnect the ribbon cables from their respective ZIF connectors on the logic board.

Adicionar comentário

Separate the rear casing from the camera.
  • Separate the rear casing from the camera.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

8 outras pessoas concluíram este guia.

Ryan Lutz

Member since: 27-09-2011

2.627 reputação

3 Guides authored

good guidance,easy to follow,thanks

ramalingeswarao kaza - Responder

I want to replace my Nikon D90 DSLR bad LCD, this guide will save me from costly repairs.

ramalingeswarao kaza - Responder

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 5

Últimos 30 dias: 31

Todo: 2,835