Peças

Não são necessárias peças.

  1. Turn over camera to find 5 apparent screws.
    • Turn over camera to find 5 apparent screws.

    Adicionar comentário

  2. Remove all 5 screws from the bottom of the camera and store them carefully.
    • Remove all 5 screws from the bottom of the camera and store them carefully.

    Adicionar comentário

    • Open battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of orange lever. Remove this screw.

    Adicionar comentário

    • Rotate camera to find side panel with lanyard attachment. Detach side panel by lifting bottom corner slightly with the spudger.

    Adicionar comentário

    • Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.

    Adicionar comentário

    • With back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.

    Adicionar comentário

    • On back of LCD screen, locate the three screws underneath the ribbon and remove them.

    Adicionar comentário

    • Take out rectangular component on the side where the screws were.

    • Pry apart screen from back casing using the spudger.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Ryan

Member since: 12-04-2011

131 reputação

6 Guides authored

Equipe

Cal Poly, Team 18-24, Garner Spring 2011 Membro de Cal Poly, Team 18-24, Garner Spring 2011

CPSU-GARNER-S11S18G24

4 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 4

Todo: 2,121