Conserte seus objetos Comunidade Loja

Nikon Coolpix S220 Accessing the Motherboard

Introdução

This guide will show how to access the motherboard which will give you the ability to remove the lens and flash.

O que você precisa

  1. Nikon Coolpix S220 Accessing the Motherboard, Outer Cover: passo 1, imagem 1 %32

    • Remove the two 2.8 mm screws on the left side of the camera.

    Editar

  2. Nikon Coolpix S220 Accessing the Motherboard: passo 2, imagem 1 %32

    • Remove the four 2.8 mm screws on the right side of the camera.

    Editar

  3. Nikon Coolpix S220 Accessing the Motherboard: passo 3, imagem 1 %32

    • Remove the three 4.1 mm screws on the bottom of the camera.

    Editar

  4. Nikon Coolpix S220 Accessing the Motherboard: passo 4, imagem 1 %32

    • Gently lift the rear cover from the camera.

    Editar

  6. Nikon Coolpix S220 Accessing the Motherboard, LCD: passo 5, imagem 1 %32

    • Gently lift the screen out of its place.

    • You will need to hold the screen slightly above the camera because it will still be attached to the camera by an orange ribbon cable.

    Editar

  7. Nikon Coolpix S220 Accessing the Motherboard: passo 6, imagem 1 %32

    • Use the tweezers to lift the ZIF connector which is holding the ribbon cables that connect the LCD screen to the motherboard.

    Editar

  8. Nikon Coolpix S220 Accessing the Motherboard: passo 7, imagem 1 %32

    • Slowly pull the screen from the camera.

    Editar

  9. Nikon Coolpix S220 Accessing the Motherboard, Motherboard: passo 8, imagem 1 %32

    • Remove the four 3.8 mm screws located near the bottom right and top left of the LCD base plate.

    Editar

  10. Nikon Coolpix S220 Accessing the Motherboard: passo 9, imagem 1 %32

    • Lift up silver LCD base plate

    Editar

  11. Nikon Coolpix S220 Accessing the Motherboard: passo 10, imagem 1 %32 Nikon Coolpix S220 Accessing the Motherboard: passo 10, imagem 2 %32

    • Using tweezers, lift up the retaining flap on the ZIF connector securing the button panel ribbon cable.

    • Slide the button panel ribbon cable out of its socket on the motherboard.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas executaram este guia.

Autor(a)

com 4 outros contribuidores

Shauna

Membro desde: 04/05/11

798 Reputação

Autoria de 5 guias

Emblemas: 14

+11 outros emblemas

Equipe

Cal Poly, Team 12-32, Maness Spring 2011 Membro de Cal Poly, Team 12-32, Maness Spring 2011

CPSU-MANESS-S11S12G32

Membros da 4

Autoria de 10 guias

Um comentário

It would be nice to have a guide for replacing the flash capacitor.

danwat1234 - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 4

Duração total: 5,613