Introdução

In order to reach the internal elements of the camera (lens, flashbulb, etc.), the following steps will tell you how to remove the front cover.

Peças

Não são necessárias peças.

Remove the memory stick from the camera.
  • Remove the memory stick from the camera.

  • Remove the batteries from the camera.

Adicionar comentário

Remove all six 4.3mm silver screws along the perimeter of the camera using the Phillips #00 screwdriver.
  • Remove all six 4.3mm silver screws along the perimeter of the camera using the Phillips #00 screwdriver.

  • There is one screw hidden under the AV cover that also needs to be removed.

Adicionar comentário

  • Pry the back cover from the left side of the camera. Remove the cover gently.

Adicionar comentário

  • CAUTION! This is where energy for the flash is stored. Even with batteries removed, if you touch these connections, you can be shocked, depending on if the flash capacitor has a stored charge. It may not have a stored charge, but work around this assuming it does.

  • Newer cameras of descent quality usually have a bleeder resistor to drain the flash capacitor. This may not work anymore and the flash capacitor may still have a charge.

Adicionar comentário

  • Remove the tape on the right side of the LCD screen.

  • Gently lift the LCD screen from its base.

  • Don't tug on the screen because it is still connected to the logic board.

Be very careful not to touch the flash capacitor on far left when lifting the LCD!! It WILL shock you.

Mark Fraylick - Responder

Getting the LCD ribbon back "in" is my problem -- hints or suggestions?

richardkujawa - Responder

I can't get a feel for how the black clip holds the ribbon - insert the new one at an angle?

richardkujawa - Responder

I practiced a few times with the "bad screen" and managed to figure this out. Unfortunately I can't explain how I did it... if some other person can explain how to make the ribbon connection/clip re-install more predictable I think it'd help anyone else who tries the repair.

richardkujawa - Responder

  • Lift the black latch connecting the LCD ribbon to the logic board.

  • Gently pull the LCD ribbon out.

Adicionar comentário

  • Pry back the front cover of the camera starting from the right side.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Andrea Govea

Member since: 11-10-2010

357 reputação

2 Guides authored

Equipe

Cal Poly, Team 9-23, Regan Fall 2010 Membro de Cal Poly, Team 9-23, Regan Fall 2010

CPSU-REGAN-F10S9G23

4 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Todo: 2,894