Introdução

This guide provides shows you how to replace your LCD screenon your Nikon Coolpix 4100 with step-by-step instructions and photographs.

Tool on left - PH000 screwdriver
  • Tool on left - PH000 screwdriver

  • Tool on right - iPod fix-it tool

  • Soldering Iron

Adicionar comentário

Locate the 3 black screws on the bottom of the camera and the 2 gray screws on each side of the camera. Remove them with a PH000 screwdriver.
  • Locate the 3 black screws on the bottom of the camera and the 2 gray screws on each side of the camera. Remove them with a PH000 screwdriver.

Adicionar comentário

Locate the gray band that you removed the screws from; this holds the two halves of the camera together.  Use an iPod fix-it tool to pry the gray band loose and remove it. Locate the gray band that you removed the screws from; this holds the two halves of the camera together.  Use an iPod fix-it tool to pry the gray band loose and remove it.
  • Locate the gray band that you removed the screws from; this holds the two halves of the camera together. Use an iPod fix-it tool to pry the gray band loose and remove it.

Adicionar comentário

Use the iPod fix-it tool to separate the back panel from the camera.
  • Use the iPod fix-it tool to separate the back panel from the camera.

Adicionar comentário

Use the iPod fix-it tool to carefully pry the screen from the logic board.
  • Use the iPod fix-it tool to carefully pry the screen from the logic board.

  • There's a ribbon cable that connects the screen to the logic board.

Adicionar comentário

This view shows the ribbon cable that connects to the screen.
  • This view shows the ribbon cable that connects to the screen.

Adicionar comentário

Flip the screen down.  To disconnect the ribbon cable from the logic board, rock each end of the brown metal retainer that holds the ribbon cable in place until the ribbon disconnects.
  • Flip the screen down. To disconnect the ribbon cable from the logic board, rock each end of the brown metal retainer that holds the ribbon cable in place until the ribbon disconnects.

Adicionar comentário

Remove the two screws on the top edge of the circuit board to the right of the viewfinder.
  • Remove the two screws on the top edge of the circuit board to the right of the viewfinder.

Adicionar comentário

To connect the new screen, solder the wires in place and connect the ribbon cable to the logic board.
  • To connect the new screen, solder the wires in place and connect the ribbon cable to the logic board.

Adicionar comentário

Unthread the four wires running across the top of the viewfinder from the plastic brackets holding them in place.
  • Unthread the four wires running across the top of the viewfinder from the plastic brackets holding them in place.

Adicionar comentário

Remove the two black screws threaded vertically into the top of the viewfinder. Loosen the flash and circuit board for more accessibility.  This will allow for the viewfinder to be replaced.
  • Remove the two black screws threaded vertically into the top of the viewfinder. Loosen the flash and circuit board for more accessibility. This will allow for the viewfinder to be replaced.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Travis Buck

Member since: 25-09-2012

107 reputação

2 Guides authored

Equipe

Ohio State, Team 1-2, Buehl Fall 2012 Membro de Ohio State, Team 1-2, Buehl Fall 2012

OSU-BUEHL-F12S1G2

3 Membros

3 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 893