Peças

Não são necessárias peças.

  1. With the lens facing forward, remove the one 4.2 mm screw on the bottom right hand corner of the camera.
    • With the lens facing forward, remove the one 4.2 mm screw on the bottom right hand corner of the camera.

    Adicionar comentário

  2. Remove the chrome side cover from the body of the camera.
    • Remove the chrome side cover from the body of the camera.

    Adicionar comentário

    • Remove the four 3.2 mm screws on the bottom of the camera.

    Adicionar comentário

    • Remove the two 3.2 mm screws from the right side of the camera (with lens is facing forward)

    • Remove the one 3.2 mm screw from the left side of the camera (with lens facing foward)

    Adicionar comentário

    • Gently separate the back cover from the body of the camera.

    • The back casing will still be connected to the circuit board by a ribbon

    Adicionar comentário

    • Use the tweezers to disconnect the ribbon from the circuit board.

    Adicionar comentário

    • Remove the one 2.6 mm screw from the left side of the camera (with the lens facing forward)

    Adicionar comentário

    • Gently separate the front cover from the body of the camera.

    • The front casing will still be connected to the circuit board by a few wires

    Adicionar comentário

    • Remove the two 3.2 mm screws that hold the flash to the front cover.

    Adicionar comentário

    • Use the Spudger to remove the copper colored light bulb clip.

    • Remove the front cover entierly from the camera body.

    Adicionar comentário

    • From the top view of the camera, remove the one 5.8 mm screw.

    • From the top view of the camera, remove the one 2.8 mm screw

    Adicionar comentário

    • Remove the three 3.4 mm screws from the back side of the camera.

    Adicionar comentário

    • Remove the two 3.4 mm screws from the side of the camera.

    Adicionar comentário

    • Separate the two metal body pieces from the rest of the camera.

    Adicionar comentário

    • Gently remove the two ribbons connecting the lens to the mother board.

    Adicionar comentário

    • Gently separate the camera lens from the mother board.

    Adicionar comentário

    • The mother board is permanently fixed to the battery housing.

    • Mother board cannot be taken a part any further.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

andreas anggasastra

Member since: 14-09-2011

116 reputação

5 Guides authored

Equipe

Cuesta, Team 1-6, Zipperian Fall 2011 Membro de Cuesta, Team 1-6, Zipperian Fall 2011

CUESTA-ZIPPERIAN-F11S1G6

2 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 1,105