Nikon COOLPIX S610c Rear Casing Replacement

Este guia tem alterações mais recentes. Mudar para a última versão não verificada.

Introdução

If your rear casing needs to be replaced, if it's been cracked for example, follow this guide to remove the current rear case. In this guide ZxY denotes a screw with Z-length and Y-width.

O que você precisa

Passo 1 Battery

Nikon COOLPIX S610c Rear Casing Replacement, Battery: passo 1, imagem 1 %32

On the bottom right of the camera, locate the battery flap switch.

Editar

Passo 2

Move this switch to the right so the battery flap can flip open.

Editar

Passo 3

Slide the orange switch to the right as shown. Now the battery can be pulled out. Reverse these steps to re-install.

Editar

Passo 4 Rear Casing

Nikon COOLPIX S610c Rear Casing Replacement, Rear Casing: passo 4, imagem 1 %32

Remove the three 3x3mm screws attached to the rear casing.

Editar

Passo 5

The panel can be identified by the wifi logo on its upper half on the camera's side.
Remove the 5x3mm screw holding down the panel on the side closest to the lens.

Editar

Passo 6

Pry the panel off from the bottom using your fingernail.

Editar

Passo 7

Remove the 3x2mm screw underneath the panel near the top of the camera.

Editar

Passo 8

Remove the 4x3mm on the opposite side near the selector wheel.
Remove the 2x2mm and 3x2mm screws underneath the a/v flap.

Editar

Passo 9

Pry the back panel away from the body of the camera, using the space you just opened up.
Be careful not to damage the ribbon cable on the opposite end of the camera.
A small piece of the frame of the camera may fall off, but it can be easily put back into place during reassembly.

Editar

Passo 10

Pry up the plastic ribbon connectors on the body of the camera to release the ribbon cables.
The center connector is detached by flipping the black latch up and away from the center of the camera.
The smaller connector is detached by flipping the tan latch up and away from the edge of the camera.