Introdução

If your rear casing needs to be replaced, if it's been cracked for example, follow this guide to remove the current rear case. In this guide ZxY denotes a screw with Z-length and Y-width.

Peças

Não são necessárias peças.

On the bottom right of the camera, locate the battery flap switch.
  • On the bottom right of the camera, locate the battery flap switch.

Adicionar comentário

Move this switch to the right so the battery flap can flip open.
  • Move this switch to the right so the battery flap can flip open.

Adicionar comentário

Slide the orange switch to the right as shown. Now the battery can be pulled out. Reverse these steps to re-install.
  • Slide the orange switch to the right as shown. Now the battery can be pulled out. Reverse these steps to re-install.

Adicionar comentário

Remove the three 3x3mm screws attached to the rear casing.
  • Remove the three 3x3mm screws attached to the rear casing.

Adicionar comentário

The panel can be identified by the wifi logo on its upper half on the camera's side.
  • The panel can be identified by the wifi logo on its upper half on the camera's side.

  • Remove the 5x3mm screw holding down the panel on the side closest to the lens.

Adicionar comentário

Pry the panel off from the bottom using your fingernail.
  • Pry the panel off from the bottom using your fingernail.

Adicionar comentário

Remove the 3x2mm screw underneath the panel near the top of the camera.
  • Remove the 3x2mm screw underneath the panel near the top of the camera.

Adicionar comentário

Remove the 4x3mm on the opposite side near the selector wheel. Remove the 2x2mm and 3x2mm screws underneath the a/v flap.
  • Remove the 4x3mm on the opposite side near the selector wheel.

  • Remove the 2x2mm and 3x2mm screws underneath the a/v flap.

Adicionar comentário

Pry the back panel away from the body of the camera, using the space you just opened up. Be careful not to damage the ribbon cable on the opposite end of the camera.
  • Pry the back panel away from the body of the camera, using the space you just opened up.

  • Be careful not to damage the ribbon cable on the opposite end of the camera.

  • A small piece of the frame of the camera may fall off, but it can be easily put back into place during reassembly.

Adicionar comentário

Pry up the plastic ribbon connectors on the body of the camera to release the ribbon cables. The center connector is detached by flipping the black latch up and away from the center of the camera.
  • Pry up the plastic ribbon connectors on the body of the camera to release the ribbon cables.

  • The center connector is detached by flipping the black latch up and away from the center of the camera.

  • The smaller connector is detached by flipping the tan latch up and away from the edge of the camera.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Kevin Backers

Member since: 26-01-2012

301 reputação

4 Guides authored

Equipe

Cal Poly, Team 9-5, Regan Winter 2012 Membro de Cal Poly, Team 9-5, Regan Winter 2012

CPSU-REGAN-W12S9G5

5 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 769