Netgear Arlo 2 Camera HD Security System SYNC Button Replacement

Introdução

This guide will explain the process of removing the Sync button on the device. It is important to remember that if you are having connection problems it could be a simple hardware problem. To best use this guide the Phillips 00 screwdriver is recommended. The Phillips 000 or 0 may work as well, please note that the smaller the screwdriver the higher chances of stripping the screw. It is also recommended to have a plastic opening tool (blue) to gently pull the device apart and a bowl or container to keep the small and easily lost screws in.

O que você precisa

Passo 1 Case

Netgear Arlo 2 Camera HD Security System SYNC Button Replacement, Case: passo 1, imagem 1 %32

Netgear Arlo 2 Camera HD Security System SYNC Button Replacement, Case: passo 1, imagem 2 %32

Netgear Arlo 2 Camera HD Security System SYNC Button Replacement, Case: passo 1, imagem 3 %32

Unscrew the two 3.0 mm Phillips #00 screws on the bottom of the camera.
Open the battery compartment on the bottom by pushing the switch marked in orange to the side and pushing the bottom of the camera back, sliding it open.

Editar

Passo 2

Remove the bottom piece of the case over the battery compartment by placing a plastic opening tool underneath the edge of the case and prying it up.
Unscrew the four 3.0 mm Phillips #00 screws on the outside of the battery pocket.

Editar

Passo 3

When facing the camera lens, the left panel of the case will be removed first (more steps are needed for the right panel).
Place the plastic opening tool between the two pieces of the case and pry them apart from the bottom.
Gently pull the side of the case off as it comes loose.

Editar

Passo 4

Unscrew the smaller 3.0 mm Phillips #00 screw in the center on the back of the device.
Flip the camera over and unscrew the center 3.0 mm Phillips #00 screw above the SYNC button.

Editar