Peças

Não são necessárias peças.

  1. Place the monitor face down on a clean, flat surface.
    • Place the monitor face down on a clean, flat surface.

    Adicionar comentário

  2. Firmly remove the back panel of the stand by pulling it up and away from the monitor.
    • Firmly remove the back panel of the stand by pulling it up and away from the monitor.

    Adicionar comentário

    • Unscrew the two 6mm Phillips PH2 screws to detach the stand enclosure from the stand.

    Adicionar comentário

    • Firmly grasp the stand enclosure with your hand and slide it to base of stand.

    Adicionar comentário

    • Unscrew the two 14.5mm Phillips PH2 screws holding the stand to the monitor.

    Adicionar comentário

    • Lift the the stand straight up to remove it.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Place the monitor screen face up.

    • Pull the frame off by placing your fingers on the inside of the frame and pulling out and up, the frame should snap off.

    • Continue your way around the screen.

    Adicionar comentário

    • Unscrew the two 7mm screws from the bottom of the button assembly.

    • Do not pull the button assembly out too quickly or with too much force! Damage to the wires can occur.

    • Pull the button assembly out a few inches and unplug the colored cables.

    Adicionar comentário

    • Unscrew the gold colored 7mm Phillips PH000 screw holding the button assembly to the monitor.

    • Remove the button assembly from the monitor.

    Adicionar comentário

    • With the monitor face-down, unscrew the 5 7mm Phillips PH2 screws around the outside of the enclosure.

    Adicionar comentário

    • Unscrew the 2 14.5mm Phillips PH2 screws located on the raised center of the enclosure.

    • Carefully pull the enclosure off the monitor.

    Adicionar comentário

    • Unscrew the 10 5mm Philips PH2 screws holding the metal casing to the monitor.

    Adicionar comentário

    • Pull the the metal casing off of the monitor to reveal the motherboards.

    Adicionar comentário

    • Carefully insert the prying tool underneath the power supply fuse.

    • Using the prying tool, lift the power supply fuse out of its emplacement until it is resting on its clamps.

    Adicionar comentário

    • Carefully remove the power supply fuse by hand.

    Adicionar comentário

    • Place the replacement power supply fuse on the fuse clips.

    • With a finger, press down on the ends of the replacement fuse until it is properly seated in the fuse clips.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Drew Troxell

Member since: 18-10-2013

113 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 11-36, Amido Fall 2013 Membro de Cal Poly, Team 11-36, Amido Fall 2013

CPSU-AMIDO-F13S11G36

5 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 4

Todo: 451