Introdução

This guide describes how to replace the button key board, or the processor that interprets key pad information.

Remove battery cover by pushing down release lever at top of phone while prying off cover. Set cover aside. Set cover aside.
  • Remove battery cover by pushing down release lever at top of phone while prying off cover.

  • Set cover aside.

Adicionar comentário

Remove battery by grabbing it near the bottom and lifting out. Remove battery by grabbing it near the bottom and lifting out.
  • Remove battery by grabbing it near the bottom and lifting out.

Adicionar comentário

Unscrew four corner screws with T6 screwdriver. Note: The two top screws are short and silver.  The two bottom screws are black and long.
  • Unscrew four corner screws with T6 screwdriver.

    • Note: The two top screws are short and silver. The two bottom screws are black and long.

Adicionar comentário

Free Shipping on all orders US$79,00 and up.

Visite Nossa Loja
MANTA DRIVER KIT
112 bit driver kit $59.99
MANTA DRIVER KIT
112 bit driver kit $59.99
Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift. Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift. Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.
  • Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.

Adicionar comentário

Starting from left side of phone, remove side buttons and place aside. Note: There should be three buttons. One on each side, and the top. Return phone to starting orientation when done.
  • Starting from left side of phone, remove side buttons and place aside.

    • Note: There should be three buttons. One on each side, and the top.

  • Return phone to starting orientation when done.

Adicionar comentário

Gently remove orange ribbon cable by prying up with spudger. Gently remove orange ribbon cable by prying up with spudger. Gently remove orange ribbon cable by prying up with spudger.
  • Gently remove orange ribbon cable by prying up with spudger.

Adicionar comentário

Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting. Note: Orange ribbon cable is fragile and can be broken.
  • Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.

    • Note: Orange ribbon cable is fragile and can be broken.

Adicionar comentário

Insert spudger under button board and gently lift, set aside. Insert spudger under button board and gently lift, set aside.
  • Insert spudger under button board and gently lift, set aside.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Eric Freeman

Member since: 26-01-2010

1 reputação

13 Guides authored

Equipe

Cal Poly, Team 8-48, Regan Winter 2010 Membro de Cal Poly, Team 8-48, Regan Winter 2010

CPSU-REGAN-W10S8G48

4 Membros

13 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 1,277