Introdução

Use this repair guide to replace the back housing in a Motorola RAZR2 v9m.

Peças

Não são necessárias peças.

Push the rear cover toward the hinge of the RAZR2.  The panel will slide about 3 mm.
  • Push the rear cover toward the hinge of the RAZR2. The panel will slide about 3 mm.

Adicionar comentário

Pinch the top and bottom edges of the panel and pull it away from the RAZR2.
  • Pinch the top and bottom edges of the panel and pull it away from the RAZR2.

  • The rear panel uses four small hooks to hold it in place. If the panel will not easily pull away, slide the panel more toward the hinge.

Adicionar comentário

  • Gently pull the white plastic tab to lift the battery away from the RAZR2.

  • The white plastic tab is attached to the phone. Only pull it enough to expose the edges of the battery.

Adicionar comentário

  • To remove the battery, grasp its edges pull away from the phone.

  • When installing a new battery, be sure the metal contacts on the phone line up with the ones on the battery.

Adicionar comentário

  • Gently press the pointy end of the spudger into the edge of the bumper until it bows and separates from the phone.

    • The bumper is held in place with adhesive. If you plan on reusing the bumper, then use clean tools to keep the surface sticky.

  • Grab the bowed portion of bumper. Gently lift and peel the bumper away from the phone.

    • Remember that the bumper will be sticky. Place it somewhere clean if you will be reusing it.

Adicionar comentário

  • Remove the two 4-mm T5 Torx screws, previously hidden beneath the flip stop bumper pad.

Adicionar comentário

  • Close the phone and flip it onto its back.

  • Remove the two 4-mm T5 Torx screws.

Adicionar comentário

  • Wedge the spudger about 4 mm into the gap between the phone casing and the rear housing.

  • Pry the rear housing away from the phone until enough is exposed to grasp with your fingers.

Adicionar comentário

  • Tilt the loosened half of the rear housing away from the phone. The housing should easily separate after tilting it about 45 degrees away from the phone.

  • A small rubber cap (marked in red on the third image) loosely sits on the motherboard. It can easily fall off when removing the rear housing. Take care not to lose it.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Todo: 599