Ir para o conteúdo principal

Motorola Moto Q Back Casing Replacement

O que você precisa

  1. Motorola Moto Q Back Casing Replacement, Back Casing: passo 1, imagem 1 %32
    • Use the Push Pin to remove the rubber screw covers by pushing the needle into the rubber and pulling up.

    • Be careful not to poke yourself when handling the push pin because it is very sharp.

  2. Motorola Moto Q Back Casing Replacement: passo 2, imagem 1 %32
    • Use the T6 screwdriver to remove the four screws holding the casing together.

    • Note: they are in the same place where you removed the four rubber coverings

  3. Motorola Moto Q Back Casing Replacement: passo 3, imagem 1 %32 Motorola Moto Q Back Casing Replacement: passo 3, imagem 2 %32
    • Wedge the plastic opening tool in between the top and bottom cases. This may require a little or a lot of force so be careful.

    • Note: the phone should be face up and the plastic opening tool should be face downwards

    • Once you get the plastic opening tool in, slide it across the side of the phone, making sure to keep the plastic opening tool wedged in between the two casings.

    • Repeat the 3 steps above for the top, bottom, and opposite side.

  4. Motorola Moto Q Back Casing Replacement: passo 4, imagem 1 %32 Motorola Moto Q Back Casing Replacement: passo 4, imagem 2 %32
    • Gently lift and remove the back casing.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Luis Herrera

Membro desde: 01/21/10

52 Reputação

Autoria de 4 guias

Equipe

Cal Poly, Team 16-33, Maness Winter 2010 Membro de Cal Poly, Team 16-33, Maness Winter 2010

CPSU-MANESS-W10S16G33

Membros da 4

Autoria de 10 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 4

Duração total: 5,141