Skip to main content

Introdução

If the stand housing is cracked and cannot hold up the camera of the baby monitor, then this guide shows consumers percisely how to remove and replace the stand.

Peças

Nenhum componente especificado.

  1. Remove two 5 mm Phillips #1 screws from the bottom of the camera stand. Remove two 5 mm Phillips #1 screws from the bottom of the camera stand.
    • Remove two 5 mm Phillips #1 screws from the bottom of the camera stand.

  2. Use a nylon spudger to remove the casing.
    • Use a nylon spudger to remove the casing.

  3. Kits de reparo de android

    A new screen or battery is one kit away.

    Comprar agora

    Kits de reparo de android

    A new screen or battery is one kit away.

    Comprar agora
  4. Remove the two 5 mm Phillips #1 screws attached to the black plastic under the casing.
    • Remove the two 5 mm Phillips #1 screws attached to the black plastic under the casing.

  5. Remove the black circular plastic part. Remove the black circular plastic part.
    • Remove the black circular plastic part.

  6. Remove the white plastic wire housing beneath the black plastic.
    • Remove the white plastic wire housing beneath the black plastic.

  7. Now, remove the bottom of the stand by pulling it from the camera. Now, remove the bottom of the stand by pulling it from the camera.
    • Now, remove the bottom of the stand by pulling it from the camera.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 106