Introdução

The screen is an essential component to all phones. There could be various instances when the screen of your phone begins to malfunction. The following guide will take you step by step on how to install a new screen on your Motorola Defy XT.

Peças

Não são necessárias peças.

  1. Wedge the plastic opening tool in between the back cover and the body of the phone in the opening denoted by the arrow.
    • Wedge the plastic opening tool in between the back cover and the body of the phone in the opening denoted by the arrow.

    Adicionar comentário

  2. Once wedged in the opening, slide the opening tool sideways around the sides of the phone. Remove the back cover and set it aside.
    • Once wedged in the opening, slide the opening tool sideways around the sides of the phone. Remove the back cover and set it aside.

    Adicionar comentário

    • Insert the opening tool between the battery and the battery holder and wedge the battery out.

    Adicionar comentário

    • Open the plastic cover with your finger, exposing the SD card.

    • Use the opening tool to grab the edge of the SD card and pull it straight out.

    Adicionar comentário

  3. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
    • Use the Torx T4 torque driver to remove the six 5mm screws on the back case.

    • Six 3 mm coarse thread screws.

    Adicionar comentário

    • Use the plastic opening tool to pop the volume buttons off.

    Adicionar comentário

    • Wedge the plastic opening tool between the plastic layer and the shiny front cover.

    Adicionar comentário

    • Slide the plastic opening tool along the edge wedging the the two pieces apart.

    • Do not completely separate the two pieces, there are still internal components that need to be disconnected.

    Adicionar comentário

    • Slide the screen out and disconnect the ribbon cable connecting the display to the logic board by pulling straight outward.

    • Be careful when sliding out the screen because the front case and the logic board are still connected by two other ribbon cables.

    Adicionar comentário

    • Set the screen aside.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Oscar Camacho

Member since: 19-04-2013

89 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 2-22, Maness Spring 2013 Membro de Cal Poly, Team 2-22, Maness Spring 2013

CPSU-MANESS-S13S2G22

3 Membros

4 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 2

Últimos 30 dias: 4

Todo: 2,807