Peças

Não são necessárias peças.

  1. Wedge the opening tool in between the back cover and the body of the phone in the opening denoted by the arrow.
    • Wedge the opening tool in between the back cover and the body of the phone in the opening denoted by the arrow.

    Adicionar comentário

  2. Once wedged in the opening, slide the plastic opening tool sideways around the sides of the phone.
    • Once wedged in the opening, slide the plastic opening tool sideways around the sides of the phone.

    Adicionar comentário

    • Insert the opening tool in between the battery and the battery holder and wedge the battery out.

    Adicionar comentário

    • Open the plastic cover with your finger exposing the SD Card

    • Use a plastic opening tool to grab the edge of the SD card and pull it straight out.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use the opening tool to grab the edge of the SD Card and pull it straight out.

    Adicionar comentário

    • Use the T4 torque driver to remove the 6 3mm diameter screws

    Adicionar comentário

    • Use the opening tool to pop the volume buttons off

    Adicionar comentário

    • Slide the opening tool along the edge wedging the two pieces apart

    • Caution: Be careful to not to rip the ribbon that is holding the two pieces

    Adicionar comentário

    • Disconnect the ribbon connector, and slide out the screen.

    Adicionar comentário

    • Flip the mother board over and disconnect the ribbon cable connecting the display to the logic board by pulling straight outward with, using the opening tool

    Adicionar comentário

    • 13. Pull the two halves of the device apart to disconnect the second (wider) ribbon connector.

    • Note: The ribbon connector is bonded to the logic board with adhesive, simply pull it off

    Adicionar comentário

    • Flip the mother board over, and use the opening tool to disconnect the camera from the logic board

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Mustapha Nadri

Member since: 19-04-2013

1 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 2-22, Maness Spring 2013 Membro de Cal Poly, Team 2-22, Maness Spring 2013

CPSU-MANESS-S13S2G22

3 Membros

4 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 5

Todo: 774