Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Introdução

This guide will go through the steps of replacing the speaker for the Motorola MB525 starting from the tear down of the phone to replacement of the speaker itself.

  1. Using the screwdriver and the T-5 bit, unscrew the seven 5 mm screws around the outside of the phone.
    • Using the screwdriver and the T-5 bit, unscrew the seven 5 mm screws around the outside of the phone.

  2. Remove the back cover of the phone by sliding the bottom black button to the unlock position and lifting it up. Remove the back cover of the phone by sliding the bottom black button to the unlock position and lifting it up.
    • Remove the back cover of the phone by sliding the bottom black button to the unlock position and lifting it up.

  3. Use a plastic opening tool to pry the battery out of the phone.
    • Use a plastic opening tool to pry the battery out of the phone.

  4. Unscrew the two silver screws located at the top of the back of the phone.
    • Unscrew the two silver screws located at the top of the back of the phone.

  5. Use a plastic opening tool to gently pry the midframe from the rest of the phone.
    • Use a plastic opening tool to gently pry the midframe from the rest of the phone.

  6. Use metal spudger to pry off the middle yellow flap carefully. Use metal spudger to pry off the middle yellow flap carefully.
    • Use metal spudger to pry off the middle yellow flap carefully.

  7. Use tweezers again to pry off the second yellow flap carefully. Use tweezers again to pry off the second yellow flap carefully. Use tweezers again to pry off the second yellow flap carefully.
    • Use tweezers again to pry off the second yellow flap carefully.

  8. The motherboard is the whole green board. Pry it off carefully with tweezers from the sides and place it aside.
    • The motherboard is the whole green board. Pry it off carefully with tweezers from the sides and place it aside.

  9. Once the motherboard is removed, use either the metal tweezers or the metal spudger to remove the speaker by prying it as shown. The speaker is glued to its position, thus you will have to glue the new one back on.
    • Once the motherboard is removed, use either the metal tweezers or the metal spudger to remove the speaker by prying it as shown.

    • The speaker is glued to its position, thus you will have to glue the new one back on.

    • The speaker must be pried off carefully. It is very delicate.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Andres

Membro desde: 08/10/2014

101 Reputação

Autoria de 1 guia

Equipe

USF Tampa, Team 14-2, Leahy Fall 2014 Membro de USF Tampa, Team 14-2, Leahy Fall 2014

USFT-LEAHY-F14S14G2

4 Membros

6 Guias de autoria

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 524