Peças

Não são necessárias peças.

  1. Begin by flipping your phone over so that the back cover is facing up.
    • Begin by flipping your phone over so that the back cover is facing up.

    • Apply force to the back cover and simultaneously slide the cover down.

    • Note: Applying pressure on the ridges will make it easier to remove the cover.

    Adicionar comentário

  2. Press the button labeled "PUSH" located at the bottom back of the phone. This will release the battery.
    • Press the button labeled "PUSH" located at the bottom back of the phone. This will release the battery.

    • Lift and remove the battery.

    Adicionar comentário

    • Do not bend or scratch the SIM card. In addition, keep it away from static electricity, dust, and water.

    • Gently slide the SIM card out and lift to remove it from the phone.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use a Torx T-5 screwdriver to remove the screws on the back of the phone.

    • The screws are 6.86 mm long and 1.61mm in diameter.

    Adicionar comentário

    • Slide a pry tool underneath the adhesive rubber stip and peel it back away from the phone.

    • Repeat for the other side

    Adicionar comentário

    • Insert the pry tool in the slit on the side of the phone and slide it down until you hear an audible click and the phone bottom loosens from the top.

      • Use the pry tool to release the two hooks on each side and the two hooks at the top holding the case together.

    • Release a total of six hooks from the sides and top to free the phone into two halves.

    Adicionar comentário

    • Using a Torx T-5 screwdriver remove the screws at the top of the phone.

    • The screws are 6.86 mm long and 1.61mm in diameter.

    Adicionar comentário

    • Use plastic pry tools to free the circuit board from the case

      • There are two hooks (one on each side) holding the circuit board into the case.

    • Then grip the circuit board and lift to remove the circuit board from the case

    Adicionar comentário

    • Unhook the antenna by releasing the two hooks, one on each side of the phone.

    • Detach the antenna from the back of the circuit board

    • This small black rubber cover may detach.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Kyle Olbrich

Member since: 09-03-2012

27 reputação

4 Guides authored

Equipe

Clemson, Team 2-2, Benson Spring 2012 Membro de Clemson, Team 2-2, Benson Spring 2012

CLEM-BENSON-S12S2G2

3 Membros

15 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 4

Todo: 930