Pular para o conteúdo principal

Introdução

This guide will walk through the steps to replace the speed selector lever on the Milwaukee M12 2407-20.

Peças

Nenhum componente especificado.

  1. Remove each of the seven 14mm Pan Hd. T-10 ST screws on one side of the housing assembly using the T10 screwdriver.
    • Remove each of the seven 14mm Pan Hd. T-10 ST screws on one side of the housing assembly using the T10 screwdriver.

  2. Remove metal clip located at the base of the drill, where the battery is to be inserted.
    • Remove metal clip located at the base of the drill, where the battery is to be inserted.

    • You may need to use a spudger if the clip is too difficult to remove with your fingers.

  3. Remove the unit from the housing assembly and set the housing assembly aside. Remove the unit from the housing assembly and set the housing assembly aside. Remove the unit from the housing assembly and set the housing assembly aside.
    • Remove the unit from the housing assembly and set the housing assembly aside.

  4. Use a spudger to pry the broken speed selector lever off the assembly.
    • Use a spudger to pry the broken speed selector lever off the assembly.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 17

Todo: 109