Pular para o conteúdo principal

Introdução

Looks as though some experience with a soldering tool may be necessary, so make sure to be safe with these steps!

  1. First, apply pressure with your thumb on the top of the battery cover.
    • First, apply pressure with your thumb on the top of the battery cover.

  2. Next, pull down on the cover until it begins to slide.
    • Next, pull down on the cover until it begins to slide.

  3. Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).
    • Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).

  4. Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.
    • Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.

  5. PC Laptop Batteries

    An easy fix for a big power boost.

    Comprar agora

    PC Laptop Batteries

    An easy fix for a big power boost.

    Comprar agora
  6. Detach back part of the case by gently lifting up.
    • Detach back part of the case by gently lifting up.

  7. Remove the circuit board from the front part of the radio case.
    • Remove the circuit board from the front part of the radio case.

    • Clip the red and black connecting wires at the base closest to the circuit bored in the spots denoted by the two red circles.

  8. Scrape off the glue on the outer lining of the speaker using the metal spudger.
    • Scrape off the glue on the outer lining of the speaker using the metal spudger.

  9. Pry the speaker from the case using the metal spudger.
    • Pry the speaker from the case using the metal spudger.

    • This should not take excessive force, so make sure all remaining glue is scraped off from the edges if it will not easily come out.

  10. The speaker is now disassembled!
    • The speaker is now disassembled!

  11. Solder the new wires to the circuit board in the spots denoted by the two red circles.
    • Solder the new wires to the circuit board in the spots denoted by the two red circles.

  12. Place the speaker back inside the shell casing in the same way that it was originally placed.
    • Place the speaker back inside the shell casing in the same way that it was originally placed.

    • Accurately use a polyurethane glue around the rim of the speaker to mount it firmly back inside the plastic casing.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

James Tucker Dunn

Membro desde: 18-01-2013

371 reputação

6 Guias de autoria

Equipe

Cal Poly, Team 19-43, Regan Winter 2013 Membro de Cal Poly, Team 19-43, Regan Winter 2013

CPSU-REGAN-W13S19G43

3 Membros

9 Guias de autoria

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 1

Todo: 596