Introdução

Removing the FightPad's front case for replacing the case or front artwork.

Use tweezers to completely remove the sticker from the rear of controller.
  • Use tweezers to completely remove the sticker from the rear of controller.

Adicionar comentário

Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.
  • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

Adicionar comentário

Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases. Use the plastic opening tool to pry the two cases apart.
  • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

  • Use the plastic opening tool to pry the two cases apart.

Adicionar comentário

Remove the two rubber side grips. Remove the two rubber side grips.
  • Remove the two rubber side grips.

Adicionar comentário

Locate RS-DP-LS switch. Pull upwards on the switch to remove it.
  • Locate RS-DP-LS switch.

  • Pull upwards on the switch to remove it.

Adicionar comentário

Locate the four 8.3 mm Phillips screws on the circuit board and remove them.
  • Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

Adicionar comentário

Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board. Be careful with the wires connected to the circuit board itself as they are thin and delicate. When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.
  • Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.

  • Be careful with the wires connected to the circuit board itself as they are thin and delicate.

  • When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

Adicionar comentário

Remove the six buttons one by one by gripping the back of each one and pushing on them from the front. Use tweezers to remove the rubber part of the directional pad before you try to remove the shoulder buttons.
  • Remove the six buttons one by one by gripping the back of each one and pushing on them from the front.

  • Use tweezers to remove the rubber part of the directional pad before you try to remove the shoulder buttons.

  • When reinserting the buttons make sure they are in the correct place and oriented correctly.

Adicionar comentário

Remove the left and right shoulder buttons by sliding them out of their respective slots.
  • Remove the left and right shoulder buttons by sliding them out of their respective slots.

Adicionar comentário

Pull the plastic piece out from the bottom of the controller. Pull the plastic piece out from the bottom of the controller.
  • Pull the plastic piece out from the bottom of the controller.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Eric

Member since: 26-09-2012

81 reputação

3 Guides authored

Equipe

Cal Poly, Team 1-7, Propen Fall 2012 Membro de Cal Poly, Team 1-7, Propen Fall 2012

CPSU-PROPEN-F12S1G7

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Todo: 1,097