Ir para o conteúdo principal

Mad Catz Rock Band 4 Wireless Fender Sync Component Replacement

O que você precisa

  1. Mad Catz Rock Band 4 Wireless Fender Sync Component Replacement, Outer Casing: passo 1, imagem 1 %32
    • Flip the guitar over so it is back side up. The battery compartment should be facing up.

    • Use a size J1 head screwdriver to remove the ten 5 mm short screws.

    • Use a J1 screwdriver to remove the four 5 mm long screws on the back of the device.

  2. Mad Catz Rock Band 4 Wireless Fender Sync Component Replacement: passo 2, imagem 1 %32
    • Turn the device over so the front of the guitar is facing you.

    • Using a size J1 philips head screwdriver, remove the eleven 5 mm silver screws (circled in red) around the white panel.

  3. Mad Catz Rock Band 4 Wireless Fender Sync Component Replacement: passo 3, imagem 1 %32
    • Gently lift the white panel and twist 90 degrees clockwise.

    • Using a size J1 head screwdriver, remove the two 5 mm black screws from underneath the white panel. You should now be able to pull the guitar apart.

  4. Mad Catz Rock Band 4 Wireless Fender Sync Component Replacement, Sync Component: passo 4, imagem 1 %32
    • Remove the two black 5 mm screws (circled in red) from the back of the power button component using a size J1 philips head screwdriver. You can identify this by the code J5-B on the component.

    • Lift the small, rectangular circuit board out and set it aside.

  5. Mad Catz Rock Band 4 Wireless Fender Sync Component Replacement: passo 5, imagem 1 %32
    • Locate the sync component hardware. It is a small circuit board that sits sideways with respect to the other circuit boards around it.

    • Remove the two 5mm black screws (circled in red) holding the circuit board in place using a size J1 philips head screwdriver. The component should now slide out vertically.

  6. Mad Catz Rock Band 4 Wireless Fender Sync Component Replacement: passo 6, imagem 1 %32
    • Follow the wires connected to the sync component back to the main circuit board. Unplug the component from the main circuit board.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas executaram este guia.

Hollynn Ricker

Membro desde: 09/28/16

451 Reputação

Autoria de 2 guias

Equipe

USF Tampa, Team 1-1, Cagle Fall 2016 Membro de USF Tampa, Team 1-1, Cagle Fall 2016

USFT-CAGLE-F16S1G1

Membros da 4

Autoria de 6 guias

Um comentário

How do I replace the sync wire? Where can I purchase a new sync component?

Ange - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 5

Últimos 7 dias: 12

Últimos 30 dias: 30

Duração total: 2,203