Conserte seus objetos Comunidade Loja

Este guia tem alterações mais recentes. Mudar para a última versão não verificada.

MacBook Unibody Model A1342 Optical Drive Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

Introdução

This guide is an internal prerequisite.

O que você precisa

  1. MacBook Unibody Model A1342 Optical Drive Replacement, Optical Drive: passo 1, imagem 1 %32

    • Remove the single 12 mm Phillips screw securing the top of the rear speaker housing to the upper case.

    Editar

  2. MacBook Unibody Model A1342 Optical Drive Replacement: passo 2, imagem 1 %32

    • Remove the single 2.2 mm Phillips screw inserted horizontally into the side of the optical drive.

    • This screw is located in a gap within the right speaker assembly, and is visible only from the hinge edge.

    Editar

  3. MacBook Unibody Model A1342 Optical Drive Replacement: passo 3, imagem 1 %32

    • Use the flat end of a spudger to pry the AirPort/Bluetooth ribbon cable connector up off the logic board.

    Editar

  5. MacBook Unibody Model A1342 Optical Drive Replacement: passo 4, imagem 1 %32

    • Use the flat end of a spudger to pry the rear speaker connector up off the logic board.

    • Pry up underneath the wires.

    • This connector is very delicate and easily broken.

    Editar

  6. MacBook Unibody Model A1342 Optical Drive Replacement: passo 5, imagem 1 %32

    • Carefully rotate the rear speaker assembly (with AirPort/Antenna cables still attached) out of the lower case.

    Editar

  7. MacBook Unibody Model A1342 Optical Drive Replacement: passo 6, imagem 1 %32

    • Use the flat end of a spudger to pry the optical drive connector up off the logic board.

    Editar

  8. MacBook Unibody Model A1342 Optical Drive Replacement: passo 7, imagem 1 %32

    • Remove the single 4.5 mm Phillips screw securing the optical drive bracket to the upper case near the fan.

    Editar

  9. MacBook Unibody Model A1342 Optical Drive Replacement: passo 8, imagem 1 %32

    • Remove the two 2.5 mm Phillips screws securing the optical drive to the upper case near the optical drive opening.

    Editar

  10. MacBook Unibody Model A1342 Optical Drive Replacement: passo 9, imagem 1 %32

    • Lift the optical drive near its connector and pull it away from the upper case to remove it from the computer.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 801