Conserte seus objetos Comunidade Loja

MacBook Unibody Model A1342 Hard Drive Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

Introdução

This guide is an internal private guide used as a prereq.

O que você precisa

  1. MacBook Unibody Model A1342 Hard Drive Replacement, Hard Drive: passo 1, imagem 1 %32

    • Remove two 11 mm Phillips screws securing the hard drive bracket to the upper case.

    • These screws are captive in the hard drive bracket.

    Editar

  2. MacBook Unibody Model A1342 Hard Drive Replacement: passo 2, imagem 1 %32

    • Lift the retaining bracket out of the upper case.

    • When putting the bracket back after replacing the drive, it is easy to put in backwards. If it doesn't seat smoothly, then reverse it and try again.

    Editar

  4. MacBook Unibody Model A1342 Hard Drive Replacement: passo 3, imagem 1 %32 MacBook Unibody Model A1342 Hard Drive Replacement: passo 3, imagem 2 %32 MacBook Unibody Model A1342 Hard Drive Replacement: passo 3, imagem 3 %32

    • Lift the hard drive by its pull tab and pull it away from the upper case, minding the cable still attaching it to the logic board.

    • In some revisions of the MacBook A1342, the hard drive bracket may include two rubber brackets (as highlighted in the second picture.) The correct orientation of the rubber brackets is shown in the third picture.

    Editar

  5. MacBook Unibody Model A1342 Hard Drive Replacement: passo 4, imagem 1 %32 MacBook Unibody Model A1342 Hard Drive Replacement: passo 4, imagem 2 %32

    • Remove the hard drive cable by pulling its connector straight away from the hard drive.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 995