Ir para o conteúdo principal

Este guia tem alterações mais recentes. Mudar para a última versão não verificada.

MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

O que você precisa

  1. MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement, Hard Drive: passo 1, imagem 1 %32
    • Remove the two Phillips screws securing the hard drive bracket to the upper case.

    • These screws will remain attached to the hard drive bracket.

  2. MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement: passo 2, imagem 1 %32
    • Remove the hard drive bracket.

    • The hard drive bracket may be firmly seated against the upper case.

  3. MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement: passo 3, imagem 1 %32
    • Use the attached pull tab to lift the hard drive out of the upper case.

    • Don't try to completely remove the hard drive just yet. It is still attached to the hard drive cable.

  4. MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement: passo 4, imagem 1 %32 MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement: passo 4, imagem 2 %32
    • Pull the hard drive cable away from the body of the hard drive.

    • Remove the hard drive.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas executaram este guia.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 1,323