Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

Introdução

Prerequisite-only guide to slide the logic board and attached components out of the Mac mini's chassis.

  1. Grasp the power supply cable and lift to disconnect it from the logic board, wiggling as needed to loosen it up.
    • Grasp the power supply cable and lift to disconnect it from the logic board, wiggling as needed to loosen it up.

  2. Carefully lift the connector for the LED indicator light straight up to disconnect it from its socket on the logic board. Take care not to pry under the socket, or you may break it off the board.
    • Carefully lift the connector for the LED indicator light straight up to disconnect it from its socket on the logic board.

    • Take care not to pry under the socket, or you may break it off the board.

  3. Kits para o Nintendo Switch

    Um reparo rápido para reiniciar o jogo

    Confira kits para o Nintendo Switch

    Kits para o Nintendo Switch

    Um reparo rápido para reiniciar o jogo

    Confira kits para o Nintendo Switch
  4. Use a T10 Torx driver to remove the two 7.5 mm screws securing the logic board. Use a T10 Torx driver to remove the two 7.5 mm screws securing the logic board.
    • Use a T10 Torx driver to remove the two 7.5 mm screws securing the logic board.

  5. In this step, you'll push the logic board free from the clips holding it to the frame. Push only where directed or you may damage the fragile cooling fins. Place a thumb at each end of the exhaust vent, over the fan screw holes. Push firmly in the direction of the ports until the logic board unclips and begins to slide out of the Mac mini.
    • In this step, you'll push the logic board free from the clips holding it to the frame. Push only where directed or you may damage the fragile cooling fins.

    • Place a thumb at each end of the exhaust vent, over the fan screw holes.

    • Push firmly in the direction of the ports until the logic board unclips and begins to slide out of the Mac mini.

  6. Slide the logic board out of the case. When reinstalling the logic board, make sure to hold the thin LED indicator light cable out of the way so it doesn't get damaged.
    • Slide the logic board out of the case.

    • When reinstalling the logic board, make sure to hold the thin LED indicator light cable out of the way so it doesn't get damaged.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Jeff Suovanen

Membro desde: 06/08/2013

300.971 Reputação

256 Guias de autoria

Equipe

iFixit Membro de iFixit

Community

126 Membros

11.860 Guias de autoria

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 2

Duração total: 70