Peças

Não são necessárias peças.

  1. Start with the bottom of the laptop facing up.
    • Start with the bottom of the laptop facing up.

    Adicionar comentário

  2. Remove the 15 screws from the bottom of the laptop with a PH1 screwdriver.
    • Remove the 15 screws from the bottom of the laptop with a PH1 screwdriver.

    • Remove the bottom plate

    • Keep track of all the screws and which slot they came from, as they slightly differ. We recommend this system: lay out on a piece of paper and pretending the paper is the device. Place the screws on the paper approximately where they would go

    Adicionar comentário

    • Remove the screw holding down the battery with a PH1 screwdriver.

    • Pull out the battery.

    Adicionar comentário

    • Open the laptop up as if you were going to use it.

    • Wedge a spudger in between the screen bezel and work it around to separate it.

    Adicionar comentário

    • Remove the screws holding in the screen at the corners with a PH1 screwdriver.

    • Be very careful as the screen may tilt forward so make sure your hand is right is on the screen when the screw comes off.

    Adicionar comentário

    • Remove the bezel from the screen.

    • Remove the two screws located at the bottom of the screen using the PH1 screwdriver.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Samer Soukieh

Member since: 19-02-2018

209 reputação

Autoria de 1 guia

Equipe

USF Tampa, Team S15-G5, Boczar Spring 2018 Membro de USF Tampa, Team S15-G5, Boczar Spring 2018

USFT-BOCZAR-S18S15G5

4 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 6

Últimos 30 dias: 32

Todo: 207