Introdução

If your drive is having problems opening, the drive belt may have broken or fallen out of the track and you will need to replace it.

  1. Insert an open paper clip into the small hole on the left side of the faceplate.
    • Insert an open paper clip into the small hole on the left side of the faceplate.

    • The tray should click open, extend it fully.

    Adicionar comentário

  2. Use an opening device to push in the black tabs on the left, right and bottom of the outer chassis to unhook the faceplate.
    • Use an opening device to push in the black tabs on the left, right and bottom of the outer chassis to unhook the faceplate.

    Adicionar comentário

    • Pull the faceplate away from the main chassis.

    Adicionar comentário

    • Unscrew the four 8.5 mm screws on the bottom chassis using a Philips #2 screwdriver.

    Adicionar comentário

    • Lift the top and bottom chassis straight up in order to remove them.

    Adicionar comentário

    • Extend the tray so that the belt is accessible.

    • Remove the old belt using tweezers.

    Adicionar comentário

    • Carefully replace with the new belt by wrapping it around the larger gear first, followed by the smaller gear.

    No parts? What about the belt? Where do you get these tiny things?

    Scott Whitehill - Responder

    Use a rubber band or an plumbing o-ring

    lilleyen - Responder

Conclusão

To reassemble your device, follow these instructions in reverse order.

5 outras pessoas concluíram este guia.

James Biggs

Member since: 12-10-2011

596 reputação

3 Guides authored

Equipe

Cal Poly, Team 6-5, Regan Fall 2011 Membro de Cal Poly, Team 6-5, Regan Fall 2011

CPSU-REGAN-F11S6G5

2 Membros

3 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 13

Todo: 5,636