Introdução

If the disc tray has fallen out of alignment or has broken, you will need to replace it.

Insert an open paper clip into the small hole on the left side of the faceplate.
  • Insert an open paper clip into the small hole on the left side of the faceplate.

  • The tray should click open, extend it fully.

Adicionar comentário

Use an opening device to push in the black tabs on the left, right and bottom of the outer chassis to unhook the faceplate.
  • Use an opening device to push in the black tabs on the left, right and bottom of the outer chassis to unhook the faceplate.

Adicionar comentário

  • Pull the faceplate away from the main chassis.

Adicionar comentário

  • Unscrew the four 8.5 mm screws on the bottom chassis using a Philips #2 screwdriver.

Adicionar comentário

  • Lift the top and bottom chassis straight up in order to remove them.

Adicionar comentário

  • Extend the tray fully.

  • Push the tab on the right side to the left.

  • Push the tab on the left side to the left.

  • Remove the tray carefully.

Adicionar comentário

  • Guide the replacement tray under the beige tabs.

  • Make sure the grey piece is slid to the right, so the grey nob is under the right-hand groove of the tray.

  • Check to see that the tray extends and closes smoothly.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

James Biggs

Member since: 12-10-2011

596 reputação

3 Guides authored

Equipe

Cal Poly, Team 6-5, Regan Fall 2011 Membro de Cal Poly, Team 6-5, Regan Fall 2011

CPSU-REGAN-F11S6G5

2 Membros

3 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 9

Todo: 3,403