Ir para o conteúdo principal
  1. Using a halberd spudger, gently lift up the metal bezel that lines the lower edge of the display. Using a halberd spudger, gently lift up the metal bezel that lines the lower edge of the display.
    • Using a halberd spudger, gently lift up the metal bezel that lines the lower edge of the display.

  2. Remove the ten 3 mm screws along the bottom edge of the display with a Phillips #00 screwdriver.
    • Remove the ten 3 mm screws along the bottom edge of the display with a Phillips #00 screwdriver.

  3. Gently wedge two opening picks underneath the display. Slowly work the opening picks around the display.
    • Gently wedge two opening picks underneath the display.

    • Slowly work the opening picks around the display.

    • Add opening picks as needed to keep display separated from the frame.

    • Use caution if dealing with broken glass.

    • The iFixit suction cup tool can be used to add some extra leverage to the mix when removing the display.

  4. Gently flip the display assembly to rest on top of the keyboard. Gently flip the display assembly to rest on top of the keyboard.
    • Gently flip the display assembly to rest on top of the keyboard.

  5. Use the halberd spudger to lift the locking tab of the ZIF connector holding the black ribbon cable that runs vertically across the display. Pull out the black ribbon cable from the connector.
    • Use the halberd spudger to lift the locking tab of the ZIF connector holding the black ribbon cable that runs vertically across the display.

    • Pull out the black ribbon cable from the connector.

  6. Use the halberd spudger to lift the latch on the ZIF connector of the horizontal black ribbon cable. Pull out the horizontal black ribbon cable from the connector. Gently pull the rest of the horizontal black ribbon cable from the back of the display.
    • Use the halberd spudger to lift the latch on the ZIF connector of the horizontal black ribbon cable.

    • Pull out the horizontal black ribbon cable from the connector.

    • Gently pull the rest of the horizontal black ribbon cable from the back of the display.

  7. Use the halberd spudger to flip the metal latch of the display cable up. Using the halberd spudger, gently pull the connector out of the display. Using the halberd spudger, gently pull the connector out of the display.
    • Use the halberd spudger to flip the metal latch of the display cable up.

    • Using the halberd spudger, gently pull the connector out of the display.

  8. Gently lift the display away from the laptop frame.
    • Gently lift the display away from the laptop frame.

Conclusão

To reassemble your device, follow these instructions in reverse order.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 11

Últimos 30 dias: 43

Duração total: 578